Sennheiser EK 300 IEM Car Stereo System User Manual


 
9
Using the diversity receiver
Using the diversity receiver
To establish a transmission link, proceed as follows:
1. Switch the diversity receiver on (see next section)
2. Switch a transmitter on
(
see the instruction manual of the trans-
mitter
).
The transmission link is established and the receiver’s RF level display
RF reacts.
If you cannot establish a transmission link between transmitter and
receiver, read the chapter “Synchronizing an SR 300 IEM G3 transmitter
with the diversity receiver” on page 20.
Switching the diversity receiver on/off and adjusting
the volume
To switch the diversity receiver on:
̈ Turn the volume control ³ clockwise until it clicks.
The red ON LED ¿ lights up. The “Frequency/Name” standard display
appears on the display panel.
To switch the diversity receiver off:
̈ Turn the volume control ³ counterclockwise until it clicks.
The red ON LED ¿ goes off and the diversity receiver switches off.
To adjust the volume:
̈ Turn the volume control ³.
It is vital to observe the notes on frequency selection on page 20.
CAUTION! Hearing damage due to high volumes!
Listening at high volume levels for long periods can lead
to permanent hearing defects.
̈ Set the volume to a low level before putting the
earphones on.
̈ Do not continuously expose yourself to high volumes.