Sennheiser EK 300 IEM Car Stereo System User Manual


 
20
Synchronizing an SR 300 IEM G3 transmitter with the diversity receiver
Synchronizing an SR 300 IEM G3
transmitter with the diversity receiver
Synchronization allows you to quickly and easily transfer transmitter and
receiver settings from one device to the other, especially if you want to set
up a multi-channel system. There are two transfer directions:
1. Easy Setup Sync: Transfer from the receiver to one or several trans-
mitters
Once you have performed a frequency preset scan with a receiver, you
use the Easy Setup Sync function to transfer unused frequency presets
from the receiver to the transmitters. In order to set up a multi-channel
system, you use the diversity receiver to transfer the unused channels
from the selected frequency bank one after the other to the transmit-
ters, thus ensuring that all transmitters of a multi-channel system
operate on intermodulation-free frequencies.
2. Sync: Transfer from a transmitter to a receiver
Once you have selected and set the desired receiver settings on the
transmitter (either manually or using the Easy Setup Sync function),
you transfer these settings to a receiver. This configures the receiver
and establishes a transmission link between transmitter and receiver.
When carrying out the Sync function, the transmitter’s current
frequency bank and channel setting as well as the receiver parameters
adjusted via the “Sync Settings” submenu are transferred to the
EK 300 IEM G3 receiver via the infra-red interface.
Setting the transmitters to intermodulation-free
channels (Easy Setup Sync)
Upon delivery, the SR 300 IEM G3 transmitter and the diversity receiver are
synchronized with each other. If, however, you cannot establish a trans-
mission link between transmitter and diversity receiver, you first have to
use the diversity receiver to determine intermodulation-free channels and
then transfer these channels to the transmitters. In doing so, no transmis-
sion links are established.
̈ On all transmitters, call up the “Easy Setup” menu item.
Easy Setup Sync” appears on the display panels of the transmitters.
The RF signals of the transmitters are deactivated. The transmitters
await the transfer of a channel and a frequency bank via their infra-red
interfaces.
̈ With a diversity receiver, perform a frequency preset scan to scan the
frequency banks for unused channels (“Scan New List”, see page 15).
̈ Select a frequency bank with a sufficient number of unused channels
and a channel on this receiver (“Current List”, see page 15).
When synchronizing the SR 300 IEM G3 transmitter with a diver-
sity receiver, please observe the following:
̈ Only use a transmitter and a diversity receiver from the same
frequency range (see the type plates on the transmitter and
the diversity receiver).
̈ Make sure that the desired frequencies are listed in the
enclosed frequency information sheet.
You can also contact your Sennheiser partner who will be
pleased to calculate intermodulation-free frequencies for you.
̈ Make sure that the desired frequencies are approved and
legal in your country and, if necessary, apply for an operating
license.