Sharp PN-H701 Car Video System User Manual


  Open as PDF
of 60
 
37
E
n
IP CONTROL SETUP
1. Set IP control to ENABLE.
Select IP CONTROL SETUP with
or
and press
ENTER
. Select CHANGE and press
ENTER
. Select ENABLE with
or
and press
ENTER
.
2.Congureadvancedsecuritysettings.
Select DETAIL SETTING with
or
and press
ENTER
.
Select CHANGE with
or
and press
ENTER
.
3.Setthelogininformation.
Enter the LOGIN ID and PASSWORD with the software
keyboard (see page 29).
4.SelectNEXTandpress
ENTER
.
5.Setthecontrolport.
Enter the CONTROL PORT with the software keyboard (see
page 29).
6.SelectNEXTandpress
ENTER
.
7.
Checkyoursettings,selectCOMPLETEwith
or
,
andpress
ENTER
.
Command-basedcontrol
You can control the monitor using control commands
(see page 33) via terminal software and other appropriate
applications.
Read the manual for the terminal software for detailed
instructions.
(1) ConnectthePCtothemonitor.
Use a commercially available LAN cable to connect a PC
to the monitor. (See page 36.)
(2) Sendcommandstocontrolthemonitor.
• ThecommandsusedarethesameasthoseforRS-
232C. Refer to the communication procedure (see
page 31) for operation.
• Usablecommandsareprovidedinthecontrol
command table (see page 33).
ControllingtheMonitorwithaPC(LAN)
 previous next