Filter
Top Products
[ Installation ]
21
Installing the Magnetic Antenna
Caution
Because adhesive is used in the installation of the Rubber Antenna Cover/Tail, we
recommend that you install the antenna at or above room temperature (68° F). The
adhesive on the Rubber Cover/Tail may not adhere properly to the vehicle roof at tem-
peratures lower than this. Warmer temperatures will also make it easier to route of the
antenna cable through the rubber molding around the windows and in other areas in the
vehicle. Maximum adhesion usually occurs within 72 hours at room temperature, so you
should avoid car washes as well as other contact with the antenna and Rubber Cover/
Tail during this 72 hour period.
Warning
Be sure not to cut, damage, or puncture the external jacket of the antenna cable during
the installation procedure. Damage to the antenna cable can degrade the SIRIUS signal
or make it unavailable, and can also cause water to intrude via the cable into the antenna
causing the antenna to fail.
Do not lengthen or shorten the antenna cable by cutting it. Doing so will cause the
antenna to not function properly.
Installation
Installing the magnetic antenna consists of two steps:
Mounting the magnetic antenna and Rubber Antenna Cover/Tail on the vehicle
Routing the antenna cable through the vehicle to the Vehicle Dock
•
•