Filter
Top Products
12
GB
Back
For details on each indicator, see “Indicator information” (page 47).
I DC IN terminal
Use to connect the supplied AC adaptor
(page 17).
Rated output voltage of an AC adaptor: DC
18 V, 2.6 A
Note
The supplied AC adaptor and AC power cord
are exclusive for this unit. Do not use an AC
adaptor not supplied with this unit.
J WPS button
Use to make the network settings for the
WPS push button configuration (page 23).
K AUDIO IN terminal
Use to connect the audio output jack of an
external component.
L (LAN) port
Use to connect the network (LAN) cable
(not supplied).
M NETWORK STANDBY / STANDBY
switch
Switch between the network standby mode
and the standby mode (page 19).
N ALL RESET button (Bottom)
Press and hold until all indicators light
while the unit is being turned on and reset
to its factory default settings.
Use a thin object, such as a small pin.
The previously registered settings or
information will be reset.
Note
Network settings are also reset when you
press ALL RESET button.
ALL RESET
button
Bottom