Filter
Top Products
15
Receiving the stored stations
1 Press (SOURCE) repeatedly to select
the radio.
2 Press (MODE) repeatedly to select the
band.
3 Push the jog roller.
4 Rotate the jog roller until you find the
desired station.
5 Push the jog roller to tune in the
desired station.
Tip
Press (DISC/PRESET -) or (DISC/PRESET +) on the
card remote commander to receive the stations in the
order they are stored in memory (Preset Search
function).
If preset tuning does not work
Press (SEEK/AMS -) or (SEEK/AMS +) to
search for the station (automatic
tuning).
Scanning stops when the unit receives a
station. Repeat until the desired station is
received.
Tips
• If automatic tuning stops too frequently, turn on the
Local Seek to limit seek to stations with stronger
signals (see “Changing the sound and display
settings” on page 19).
• If you know the frequency of the station you want to
listen to, press and hold (SEEK/AMS -) or
(SEEK/AMS +) to locate the approximate frequency,
then press (SEEK/AMS) repeatedly to fine adjust to
the desired frequency (manual tuning).
If FM stereo reception is poor
Select monaural reception mode.
(see “Changing the sound and display
settings” on page 19). The sound improves,
but becomes monaural (“ST” disappears).
Tip
If FM broadcasts are difficult to hear, set DSO to off.
Automatic reception frequency
adjustment
— IF Auto function
While receiving FM stereo, interference from a
nearby station may make listening difficult. In
such cases, the “IF Auto” function of this unit
will automatically narrow the reception
frequency to eliminate noise. For this reason,
some FM stereo broadcasts may become
monaural. If you would like to hear such
broadcasts in stereo, manually switch to the
“Wide” setting.
1 During FM radio reception, press
(MENU).
2 Rotate the jog roller until “IF Auto”
appears.
3 Press (SEEK/AMS +) to select “Wide.”
4 Push the jog roller.
Note
Return to the “IF Auto” setting from the “Wide” setting
if interference makes FM stereo difficult to listen to.
Storing only the desired
stations
You can manually preset the desired stations.
1 Press (SOURCE) repeatedly to select
the radio.
2 Press (MODE) repeatedly to select the
band.
3 Press (SEEK/AMS -) or (SEEK/AMS +) to
tune in the station that you want to
store.
4 Push the jog roller.
5 Rotate the jog roller to select the
stored number.
6 Push the jog roller for 2 seconds until
“Memory” appears.
The stored station indication appears in the
display.
Note
If you try to store another station on the same stored
number, the previously stored station will be erased.