Filter
Top Products
26
Cannot turn off the “--------” indication.
You entered the name edit mode.
tPush the jog roller or press (LIST) on the
card remote commander for 2 seconds.
“ATT” appears in the display, and volume is
reduced.
The telephone ATT control lead is shorting on
a metal part of the car.
tInsulate any exposed wires with electrical
tape to avoid any short circuit.
CD/MD playback
A disc cannot be loaded.
• Another CD/MD is already loaded.
• The CD/MD is forcibly inserted upside down
or in the wrong way.
Playback does not begin.
• Defective MD or dirty CD.
• CD-R/CD-RW that is not finalized.
• You tried to playback a CD-R/CD-RW not
designed for audio use.
• Some CD-Rs/CD-RWs may not play due to
its recording equipment or the disc
condition.
A disc is automatically ejected.
The ambient temperature exceeds 50°C
(122°F).
The operation buttons do not function.
CD will not be ejected.
Press the reset button.
The sound skips from vibration.
• The unit is installed at an angle of more than
20°.
• The unit is not installed in a sturdy part of
the car.
The sound skips.
Dirty or defective disc.
Tape playback
The sound is distorted.
• The tape head is contaminated.
tClean the head with a commercially
available dry-tape cleaning cassette.
• A tape recorded with Dolby NR off is played
back with Dolby NR on.
tSet the Dolby NR to “off” (page 14).
The AMS does not operate correctly.
• There is noise in the space between tracks.
• A blank space is too short (less than 4
seconds).
• A long pause, or a passage of low
frequencies or very low sound level is treated
as a blank space.
Radio reception
Preset tuning is not possible.
• Store the correct frequency in the memory.
• The broadcast signal is too weak.
The stations cannot be received.
The sound is hampered by noises.
• Connect a power antenna control lead (blue)
or accessory power supply lead (red) to the
power supply lead of a car’s antenna booster.
(Only when your car has built-in FM/AM
antenna in the rear/side glass.)
• Check the connection of the car antenna.
• The auto antenna will not go up.
tCheck the connection of the power
antenna control lead.
• Check the frequency.
• When the DSO mode is on, the sound is
sometimes hampered by noises.
tSet the DSO mode to “off” (page 20).
Automatic tuning is not possible.
• The local seek mode is set to “on.”
tSet the local seek mode to “off” (page
20).
• The broadcast signal is too weak.
tPerform manual tuning.
The “ST” indication flashes.
• Tune in the frequency accurately.
• The broadcast signal is too weak.
tSet to the monaural reception mode (page
20).
A program broadcast in stereo is heard in
monaural.
The unit is in monaural reception mode.
tCancel monaural reception mode (page
20).
Interference occurs during FM reception.
The wide mode is selected.
tSet the IF mode to “IF Auto” (page 20).