Filter
Top Products
Manual ARM input (LT. BLUE/RED)
This wire will ARM the security system when a POS or NEG pulse is applied to it from an external device.
Manual DISARM Input (LT. BLUE/BLACK)
This wire will DISARM the security system when a POS or NEG pulse is applied to it from an external device.
Unlock Switch Sense (LT. BLUE/GREEN)
This wire will prevent the system from disarming the security system when a POS or NEG pulse is applied to it
from an external device. This will prevent the system from disarming if it is pulsed at the same time as the LT.
BLUE/BLACK (Manual Disarm Input) wire.
For example: To prevent the system from disarming from the switch on the door. Connect this wire to the unlock
switch or passenger unlock motor wire.
NOTE: Only required if using the factory keyless entry transmitter to arm/disarm this system.
Song Bird Output (BROWN/WHITE) SB1 Accessory required
This wire controls the SB1 accessory (Not Included).
Connect this wire to one of the WHITE/BLACK wires from the SB1.
Trunk Pin Switch Input (-) (BLUE)
Connect the BLUE wire to an optional grounding type trunk pin switch.
2. 22 PIN BASE HARNESS CONTINUED
Trunk Release Output (+/-) (PINK)
Locate the vehicle’s trunk release wire at the trunk release switch.
Verification: This wire will register either positive voltage or ground when the trunk release is activated.
Positive Polarity Systems:
Connect the PINK wire to the vehicle’s trunk release wire. Refer to Fuse Placement Diagram below.
Negative Polarity Systems:
Connect the PINK wire to the vehicle’s trunk release wire. Refer to Fuse Placement Diagram below
(+)
(-)
P
ositive Polarity Outp
ut
(+)
(-)
N
egative Polarity Outp
ut