Chapter 2. Hardware Setup
11
Single Stage Installation
In a Single Stage installation, there are no additional switches daisy chained
down from the first unit. To set up a single stage installation, refer to the
installation diagram on the next page (the numbers in the diagram correspond
to the numbers of the installation steps), and do the following:
1. Plug your external console's keyboard, monitor, and mouse into the
Console Ports located on the switch's rear panel. The ports are color coded
and marked with an appropriate icon to indicate themselves.
Note: This step is optional.
2. For each of the computers you are installing, use a KVM cable set (as
described in the Cables section on page 4), to connect any available KVM
Port to the computer's keyboard, video and mouse ports.
Note: Ignore the daisy chain port at this time. It is only used when daisy
chaining additional KH0116 units. Daisy chaining is described in
the next section.
3. Use the Power cord provided with this package to connect the switch's
Power Socket to an AC power source.
4. Power on the switch.
5. After the switch is powered on, power on the computers.
