KL1116 User Manual
46
Beeper Control
The Beeper can be hotkey toggled On and Off. To toggle the Beeper, do the
following:
1. Invoke HKM (see page 41).
2. Press and release the [B] key.
The Beeper toggles On or Off. The Command Line displays Beeper On or
Beeper Off for one second; then the message disappears and you automatically
exit Hotkey Mode.
Hotkey Summary Table
Note: The brackets in the table above indicate keys you should press. Simply
press the indicated keys, do not type the brackets.
[Num Lock] + [-] [Port ID] [Enter] Switches the KVM focus to the computer that
corresponds to that Port ID.
[T] [n] [Enter]
Sets the Auto Scan interval to n seconds
– where
n is a number from 1–255.
[A] Invokes Auto Scan Mode.
When Auto Scan Mode is in effect, press [P] or
left-click the mouse to pause Auto Scanning.
When Auto Scanning is paused, press any key or
left-click the mouse to resume Auto Scanning.
[←] Invokes Skip Mode and skips from the current port
to the first previous accessible port.
[→] Invokes Skip Mode and skips from the current port
to the next accessible port.
[↑] Invokes Skip Mode and skips from the current port
to the last accessible port of the previous station.
If you are at a port on the First Station you cycle
backward to the last accessible port on the Last
Station.
[↓] Invokes Skip Mode and skips from the current port
to the first accessible port of the next station. If
you are at a port on the Last Station you cycle
forward to the first accessible port on the First
station.
[B] Toggles the beeper on or off.
