Selecting Lock mode 2 or toggling between mode 2 and mode 1
NOTE: If the switcher is in Lock mode 0 or mode 1, this procedure selects mode 2.
If the switcher is in Lock mode 2, this procedure selects mode 1.
Toggle the lock on and off by pressing and holding the RGBHV (CrossPoint Ultra) or Video
(MAV Plus) button and the Audio button for approximately 2 seconds (see figure 52).
I / O
VIDEO AUDIO
I / O
VIDEO AUDIO
the buttons simultaneously to turn on
k mode 2 or to toggle between mode 1 and mode 2.
2 seconds
The buttons blink
twice to indicate the
mode change.
Figure 52. Toggle Front Panel Lock Between Mode 2 and Mode 1
Performing a System Reset from the Front Panel
The front panel reset is identical to issuing the
E
ZXXX
}
SIS command defined on
page 104. A system reset performs the following functions:
• Clears all ties and presets
• Clears all video and audio mutes
• Resets all I/O grouping
• Resets all RGB delay to 0 seconds
• Resets all input audio levels to unity gain (0 dB)
• Sets all output volume levels to 100% (0 dB of attenuation)
NOTES:
• System reset does not reset the Internet protocol (IP) settings or replace user-
installed firmware.
• The system reset clears most image and audio adjustments. To save these settings,
use the Windows-based Matrix Switchers Control Program and the File > Save
MATRIX settings as... selection (see page 124) before you perform this reset.
• If background illumination was turned on before the reset, the I/O and control
buttons are unlit after the reset. But, when you cycle power, background illumination
returns to as selected.
Reset the switcher to the factory default settings by pressing and holding the RGBHV
(CrossPoint switchers) or Video (MAV Plus switchers) button and Audio button
simultaneously while you apply AC power to the switcher (see figure 53).
I / O
VIDEO AUDIO
Press and hold the buttons while you
apply power to the switcher.
Release the buttons.
Power
The switcher flashes
the button indicators
and then turns them off.
Continue to hold the buttons until all input
and output buttons return to either unlit or
to background illumination and the RGBHV
or Video and Audio buttons turn on.
Figure 53. System Reset
CrossPoint and MAV Series Matrix Switchers • Operation 76
