EQQZ022W EQQZ029E
EQQZ022W THE SSCM LOAD MODULE SPECIFIED,
SSCM
, COULD NOT BE LOADED
Explanation: The module name specified in the SSCMNAME parameter of the OPCOPTS initialization statement
could not be found.
System action: Initialization continues, using the EQQSSCMC module defined by IEFSSN
xx
for TME 10 OPC event
generation.
System programmer response: Check that the module name specified in SSCMNAME is correct, and that the
module is contained in an APF-authorized library, accessible to TME 10 OPC either by the STEPLIB DD statement or
by the LNKLST
xx
concatenation.
EQQZ023W THE SSCMNAME LOAD MODULE SPECIFIED,
SSCM
, IS NOT VALID FOR OPC/ESA
Explanation: A module name specified in an SSCMNAME keyword on an OPCOPTS initialization statement is not
valid.
System action: The TME 10 OPC subsystem continues to create event records using the EQQSSCMx module that
was loaded during IPL.
System programmer response: Specify a valid TME 10 OPC event creation routine.
EQQZ024I BEXTXT
Explanation: This message contains output from TME 10 OPC internal diagnostic routines.
System action: Normal TME 10 OPC processing continues.
System programmer response: None.
EQQZ025E THE OPC/ESA SUBSYSTEM
SSNAME
IS USING AN INVALID EQQSSCM MODULE
Explanation: The event creation routine (EQQSSCMx) used by the subsystem named in the message is not valid for
TME 10 OPC. This error was discovered during system IPL.
System action: The IPL continues. The subsystem named in the message will be active, but the tracking event that
it creates will not be reliable.
System programmer response: Verify that the correct EQQSSCMx module is accessible to the operating system
during the IPL. Check that the SYS1.PARMLIB member IEFSSNxx is correctly updated.
For more information, refer to
TME 10 OPC Installation Guide
.
EQQZ028E THE ACTION CHARACTER OF ONE OR MORE OF THE CATMDISP VALUES IS INCORRECT
Explanation: You have specified a invalid action for a message class in the CATMDISP 1keyword.
The only valid value is Q.
System action: TME 10 OPC is terminated.
User response: Correct the CATMDISP values and restart TME 10 OPC.
EQQZ029E INVALID COMBINATION OF ACTION AND NEW CLASS IN THE CATMDISP KEYWORD
Explanation: You have specified an invalid combination for the action character and the new class section of the
CATMDISP keyword value. A new class must be specified when the action character is Q, meaning the output is to be
requeued to a different class.
System action: TME 10 OPC is terminated.
User response: Correct the CATMDISP value and restart TME 10 OPC.
408 TME 10 OPC Messages and Codes
