Page 4-6 Xerox WorkCentre 4118 and FaxCentre 2218 System Administration Guide
Print Driver Installation for Networked Printers
If the network printer settings are not automatically detected, click on the [Custom] button
to setup the network printer port settings.
It is recommended that you select [RAW] as the Print Protocol.
If you prefer to use LPR:
Select [LPR] as the Print Protocol.
Enter lp (in lower case) in the [LPR print queue] field.
Uncheck the box labelled [LPR Byte Counting Enabled].
Check the box labelled [SNMP Status Enabled].
The [Community Name] should normally be set to public (unless you have configured the
device to have a custom SNMP community name) and the [SNMP Device Index] should
be set to 1.
Select [OK].
¾ The Add Printer Wizard will then request that you select the driver to be used for this
printer.
Insert the CD containing the WorkCentre 4118 / FaxCentre 2218 drivers and select [Have
Disk].
Browse to the required Windows 2000 driver on the CD and select [OK].
NOTE: The driver will be found on the appropriate PCL or PS CD, in the
Drivers>Print>ADDPrint folder. You will need to select the required language and operating
system. The driver is identified by the file extension .inf.
Select [Next], and select [Next] again and the WorkCentre 4118 / FaxCentre 2218 driver
will be loaded onto the workstation.
Enter the Printer Name and select [Next].
¾ If you wish to share the printer over the network select [Shared]. You may also wish to
install printer drivers for other operating systems that will access the printer.
A dialog box displays with a message regarding the printing of a test page.
Select [Finish] to accept the Yes choice.
¾ Continue with Test Print, see Test Print 8-16.
4
5
6
