Operator Guide Maintenance
DocuTech/DocuPrint 75/90 and DocuPrint 75 MX 4-9
CAUTION
When the power on/standby switch is in stand-by and the AC
power cord remains connected to a power receptacle, AC
voltage is present in the power supply.
10.If the equipment will be serviced or moved, disconnect the
AC power cord from the AC receptacle.
Emergency power-off procedures
An emergency power-off procedure may be used when the
power must be switched off immediately.
CAUTION
The controller emergency power off procedure may corrupt the
DocuSP software. This method should only be used in an
emergency.
Controller Power-
Off
To power off the system in an emergency use any of the
following methods:
• Switch off the controller power switch on the front of the
controller for an Ultra 30, on the back for an Ultra 10.
• On the DocuSP Print Services, the System menu, select the
option for Immediate Shutdown.
• Pull the controller power cord from its receptacle.
Printer power-off To power off the printer in an emergency use any of the following
methods:
• Press the red button on the printer.
• Pull the printer power cord from the power receptacle.
An emergency power off of the printer will not corrupt the
DocuSP system software. However, you will need to enter Reset
at the OK prompt if the controller displays the OK prompt.
Controller or
Printer Emergency
Conditions
For the printer or the controller, if any of the following conditions
occur, disconnect the power cable from the power socket
immediately and contact an authorized Xerox Service
Representative to correct the problem
• The equipment emits unusual odors, or makes unusual
noises.
