Paper and other stock Operator Guide
5-4 DocuTech/DocuPrint 75/90 and DocuPrint 75 MX
When the Top Tray of the Finisher is used: In addition to using
the Top Tray as an output location, it is also used for short-edge
feed (SEF) sheets less than 6.7 inches (170 mm) long in the feed
direction or 8 inches (203 mm) long in the cross-feed direction
will go to the Top Tray rather than to the Stacker. It is inherent to
the design of the inverter, if the sheet is too short, the output will
be sent to the top tray.
During certain jam or error conditions, purged sheets (to be
discarded) are also sent to the Top Tray.
Performance tables
In the printer performance tables, various symbols and
characters are used to convey information.
Symbols The following symbols in the “Rating” column of a table represent
the expected paper handling and image quality performance in
typical operating environments.
l = Best performance
o = Good performance
u = Fair - Good performance
x = Not recommended. Exceeds design specifications.
Unacceptable performance is likely.
** = Indicates the same performance as shown in Table 5-2. and
Table 5-3. for the corresponding paper sizes.
Characters The following characters in the “Note” column of a table provide
additional information.
a = Cannot be duplexed.
b = The output will go to the Top Tray and cannot be stapled.
32 lb or 120 gsm 33
65 lb or 244 gsm Cover to
110 or 203 gsm Index
22
Table 5-1. Staple capability for various paper weights
Weight Maximum Number of Stapled Sheets
