Filter
Top Products
17-EN
CD/MP3/Changer Operation (Optional)
Playing MP3 Files with the CD
Changer
If you connect a changer compatible with MP3,
you can play CD-ROMs, CD-Rs, and CD-RWs
containing MP3 files.
1 Press SOURCE/PWR to switch to the CD
Changer mode.
Disc Number, Folder Number, File Number and
Elapsed Time are displayed.
2 Press any one of the disc select buttons (1
through 6) corresponding to one of the discs
loaded in the CD Changer.
3 To pause playback, press -/J.
Pressing -/J again will resume playback.
Multi-Changer Selection
Alpine's Ai-NET system will support up to 6 CD
Changers. When operating two or more changers,
the KCA-400C (Multi-Changer Switching device)
must be used. If you use 1 Switching device, you
can connect up to 4 CD Changers. If you use 2
Switching devices, you can connect up to 6 CD
Changers. When using KCA-410C (Versatile Link
Terminal), you can connect two changers and two
external outputs (AUX).
1 Press SOURCE/PWR on the CVA-1004 to
activate the CD Changer mode.
Alternatively, press SOURCE on the Remote
Control to activate the CD Changer mode.
Proceed to step 3 below to select the desired CD
Changer.
2 Press BAND/TEL, or BAND on the Remote
Control, to activate the CD Changer Selection
mode.
3 The CD Changer Selection mode remains active
for 3 seconds after step 2 is performed. Press
BAND/TEL., or BAND on the Remote Control,
until the desired CD Changer indicator appears
on the display.
NOTE
If the selected CD Changer is not connected, the display
will show "NO CHANGER."
4 To operate the selected changer, see elsewhere
in this section.
NOTE
If an optional CD/DVD player is connected to the unit,
the disc mode can be switched each time you press
BAND/TEL. (see "Switching Disc Mode" on page 38.)
Setting the Range of MP3 File
Selection
When an MP3 compatible CD changer is
connected you can set the range of MP3 file
selection to “entire disc contents” or “folder
contents only.” This setting is effective for Repeat/
M.I.X./Scan play (see page 14 to 15).
After carrying out steps 1 to 3 of “To display the
SETUP screen” (page 29), perform the operation
shown below.
1 When the monitor is open, press and hold
MUTE/SETUP for at least 2 seconds. The
SETUP screen appears.
2 Press preset 6 to activate the OTHER setting
mode. Press preset 6 again to select MP3 PLAY.
3 Press g or f to select ALL or FOLDER.
ALL :
plays all the files on one disc
FOLDER:
plays files in the selected folder only
NOTE
During Repeat play, this setting is effective when
REPEAT (RPT) ALL is selected (Refer to “Repeat Play”
in page 14).
For any other settings, press preset 6 or another
preset button.
4 After setting is completed, press MUTE/SETUP
to return to normal mode.