Filter
Top Products
52-EN
Information
• No disc is inserted.
- Insert a disc.
• Although a disc is inserted, “NO DISC” is displayed and the
unit does not start to play or eject the disc.
- Remove the disc by following these steps:
1) Press the button.
The movable display will open.
2) Press the button again for at least 3 seconds while the
movable display is open.
• Remote control operation is not possible.
- For some discs or playing modes, certain operations are not
possible. This is not a malfunction.
• Disc does not match regional code number.
- Load a disc that matches the regional code number.
• PAL disc is loaded.
- Load an NTSC disc.
• Protective circuit is activated to high temperature.
- The indicator will disappear when the temperature
returns to within operation range.
- Leave the power OFF until the temperature decreases and
then turn the power ON again.
• Mechanism error.
1) Press the button and eject the disc.
If not ejecting, consult your Alpine dealer.
2) When the error indication remains after ejecting, press the
button again.
If the error indication still does not turn off after pressing the
button for a few times, consult your Alpine dealer.
NO DISC
Indication for DVD/Video CD
(Audio display)
(Monitor display)
REGIONAL CODE
VIOLATION
(Audio display)
ERROR
(Monitor display)
VIDEO SIGNAL SYSTEM IS
NOT CORRECT
(Audio display)
ERROR
(Monitor display)
HI-TEMP
HI TEMP
(Audio display)
(Monitor display)
LOADING ERROR
(Audio display)
ERROR
EJECT ERROR
(Monitor display)
Indication for CD/MP3
• Protective circuit is activated due to high temperature.
- The indicator will disappear when the temperature returns to
within operation range.
- Leave the power OFF until the temperature decreases and
then turn the power ON again.
• No disc is inserted.
- Insert a disc.
• Although a disc is inserted, “NO DISC” is displayed and the
unit does not start to play or eject the disc.
- Remove the disc by following these steps:
1) Press the button.
The movable display will open.
2) Press the button again for at least 3 seconds while the
movable display is open.
• Mechanism error.
1) Press the button and eject the CD.
If not ejecting, consult your Alpine dealer.
2) When the error indication remains after ejecting, press the
button again.
If the error indication still does not turn off after pressing
the button for a few times, consult your Alpine dealer.
• The temperature in the car is too low.
- Raise the temperature in the car to normal temperature.
NOTE
When the “ERROR” is displayed:
In case that the disc cannot be ejected by pressing the button,
press the RESET switch (refer to page 7) and press the button
again.
If not ejecting, consult your Alpine dealer.
HI TEMP
ERROR
NO DISC
Picture is unclear or noisy.
• Disc is being fast-forwarded or fast-reversed.
- The picture may be slightly disturbed, but this is normal.
• Vehicle’s battery power is weak.
- Check the battery power and wiring.
(The unit may malfunction if the battery power is under 11
volts with a load applied.)
• Monitor’s fluorescent tube is worn.
- Replace the monitor’s fluorescent tube.
Image stops sometimes.
• Disc is scratched.
- Replaced with a non-scratched disc.