Filter
Top Products
10-EN
01GB05IVAW205R.fm
ALPINE IVA-W205R 68-08564Z42-A (EN)
Inserting/Ejecting a Disc
IVA-W205R:
1
Press on the unit.
The display changes to the EJECT/TILT screen.
2
Insert a disc:
Touch [OPEN] on the EJECT/TILT screen.
The movable monitor will open, then insert a disc into the
disc slot. Inserting a disc will close the monitor
automatically.
Eject the disc:
Touch [] of DISC on the EJECT/TILT screen.
The movable monitor will open. Then the disc is ejected.
3
Touch [CLOSE] on the EJECT/TILT screen.
The movable monitor will close.
IVA-W202R:
Insert the disc:
Press .
The movable monitor will open.
Insert disc in to Disc slot part.
Eject the disc:
Press again.
Disc is ejected.
• Touching [CONTROL] or [RETURN] return to the earlier main
source screen (IVA-W205R only).
• Do not apply shock to the movable monitor when it is open as it may
result in malfunction of the unit.
• The monitor may be dim during low temperature and immediately
after turning on the power. The brightness will return to normal as
time elapses.
• The monitor will stop at the set tilt angle when closing.
Adjusting the Monitor Viewing Angle
Adjust the monitor’s angle for better visibility.
IVA-W205R:
1
Press on the unit.
The display changes to the EJECT/TILT screen.
2
Touch [] or [] of TILT to adjust the desired
monitor angle.
The monitor angle can be adjusted in 5 stages.
3
Touch [RETURN] to return to the previous screen.
IVA-W202R:
1
Touch [SETUP] for the selected source on the main
screen.
The setup selection screen is displayed.
2
Touch [DISPLAY].
3
Touch [] or [] of TILT to adjust the desired
monitor angle.
Pressing the buttons changes the screen angle by 5 stages.
4
Touch [RETURN] to return to the previous screen.
• This function is adjustable while driving.
• If the monitor touches an obstacle while the angle is being
adjusted, it will stop immediately.
• The screen colour will vary when viewed at certain angles.
Adjust the screen angle for the best viewing position.
• If the voltage of the vehicle’s battery power is low, the screen
may blink when the screen angle is changed. This is normal and
not a malfunction.
• Touching and holding [RETURN] for at least 2 seconds will
change to the main source screen.
Adjusting the Volume
Adjust the volume by pressing or .
Volume decreases/increases continuously by pressing and
holding or .
Volume: 0 - 35
• The MUTE function can be performed by using the optional remote
control.
CAUTION
Keep hands (or any other object) away from the monitor while it
is opening or closing to avoid damage or injury. The back of the
movable monitor will get very warm under normal operating
conditions. This is not a malfunction. Do not touch.
Disc Slot
68-08564Z42-A_F.book Page 10 Wednesday, January 24, 2007 2:26 PM