Filter
Top Products
48-EN
01GB06IVAW205R.fm
ALPINE IVA-W205R 68-08564Z42-A (EN)
Adjusting the DVD Level
The volume (signal level) for Dolby Digital, Dolby PL II, DTS and
PCM modes can be set.
• Avoid stopping, pausing, switching the disc, cueing, fast-forwarding
or switching the audio channel of this unit while making this
adjustment. The setting is cancelled if the Decode mode is switched.
1
Check that Defeat mode is off (page 26).
2
Touch [SETUP] on the main source screen.
The SETUP selection screen appears.
3
Touch [AUDIO].
The AUDIO SETUP screen will appear.
4
Touch [] of A.PROC.
The A.PROCESSOR list screen appears.
5
Touch [] of DVD LEVEL.
The DVD LEVEL list screen appears.
6
Adjust the level by touching [] or [] of the
desired adjusting mode.
The level can be adjusted in the range of –5 dB to +5 dB.
Storing Settings in the Memory
Adjustment or setting contents can be stored.
Contents that can be stored vary depends on the audio processor used.
1
Check that Defeat mode is off.
2
Touch [MEMORY] on the A.PROCESSOR list
display.
3
Within 5 seconds, touch any one of the preset
buttons [P.SET 1] through [P.SET 6] on the
A.PROCESSOR list screen.
The setting contents are stored.
• The stored contents will not be deleted even when the battery power
cord is detached.
Calling up the Preset Memory
1
Check that Defeat mode is off.
2
Touch any one of the preset buttons [P.SET 1]
through [P.SET 6] on the A.PROC list display to
select the preset memory.
• It takes a few moments to call up the preset memory.
Using the Pro Logic II Mode
Pro Logic processing can be conducted on the music signals recorded
on two channels to achieve Dolby Pro Logic II surround sound.
For two-channel Dolby Digital and DTS signals, there is also a
“REAR FILL” function for outputting the signals of the front channel to
the rear channel.
1
Check that Defeat mode is off.
2
Touch [SETUP] on the main source screen.
The SETUP selection screen appears.
3
Touch [AUDIO].
The AUDIO SETUP screen will appear.
4
Touch [] of A.PROC.
The A.PROCESSOR list screen appears.
5
Touch [] of DOLBY PLII/REAR FILL.
The DOLBY PLII/REAR adjusting screen appears.
6
Touch [] or [] of DOLBY PLII/REAR to select the
desired mode.
If PL II MUSIC is selected, the centre width can be adjusted with
following operations.
This function offers the optimum vocal position by adjusting the
centre channel position between the centre speaker and the L/R
speaker. (The adjustments established in “Adjusting the
acoustic image (BI-PHANTOM)” (page 47) are ineffective while
this function is activated.)
Touch [] or [] of CENTER WIDTH CONT to adjust the
level.
The level can be adjusted between ±0 to +7. When the
level increases, the centre channel position moves from
the centre speaker position to both sides.
Touch [OFF] of CENTER WIDTH CONT to turn off the
centre width control.
PL II MOVIE: Suits the stereo TV shows and all programmes
encoded in Dolby Surround. It improves the
sound field directivity to near that of discrete
5.1-channel sound.
PL II MUSIC: Can be used for all stereo music recordings, and
provides a wide, deep sound field.
OFF: Turns DOLBY PL II function to OFF.
68-08564Z42-A_F.book Page 48 Wednesday, January 24, 2007 2:26 PM