Filter
Top Products
50-EN
01GB06IVAW205R.fm
ALPINE IVA-W205R 68-08564Z42-A (EN)
3
Remove the slot panel, then insert the Portable
Navigation device in the unit (See the illustration
below).
• The slot panel can be detached by placing a finger in the hole in the
centre of the panel and pulling it down.
• If the face plate is attached, first remove the face plate, then the slot
panel. After removing the slot panel, reattach the face plate.
4
After inserting, touch [CLOSE] on the EJECT/TILT
screen.
The movable monitor will close.
5
Press SOURCE.
The SOURCE selection screen is displayed.
6
When the source name of [BLACKBIRD] on the
SOURCE selection screen is displayed, touch the
desired source name.
• For details on operation, refer to the Owner’s Manual of the Portable
Navigation device.
Removing the Portable Navigation Device
1 Press on the unit.
The display changes to the EJECT/TILT screen.
2 Touch [OPEN] or [ ] of BLACKBIRD on the EJECT/TILT
screen.
The movable monitor will open.
3 Press [ ] behind the monitor.
The Portable Navigation device is removed.
1
Select the BLACKBIRD in “Setting the AUX Mode”
(page 36).
2
Mount the Portable Navigation device to the optional
docking station.
The connection to the Portable Navigation device is
recognized in steps 1 and 2.
3
Press SOURCE.
The SOURCE selection screen is displayed.
4
Touch [BLACKBIRD].
For details on operation, refer to the Owner’s Manual of the
Portable Navigation device.
Operating Auxiliary Devices (Optional)
To operate your devices connected to the AUX terminals on the rear
panel of IVA-W205R/IVA-W202R, follow the procedure described
below.
• If you try to activate the auxiliary device while driving, the display
will show the warning-PICTURE OFF FOR YOUR SAFETY.
1
Touch [SOURCE] on the main source screen.
The source screen appears on the display.
2
Touch [AUX]*.
The external input screen is displayed.
3
Touch [NTSC/PAL] to change the video input.
* The name which is given as the source name in “Setting the AUX
Mode” on page 36 is displayed.
• If the AUX mode is not displayed on the main menu, set AUX IN to
ON by following “Setting the AUX Mode” (page 36).
• The setting of switching NTSC/PAL, which you have set in this
section, can be used in same way in “Switching the Visual Input
Signal System” on page 36.
• The display mode changes by touching [WIDE].
For operation, refer to “Switching Display Modes” on page 28.
• After connecting the KCA-410C, its AUX input can be used only in
INTERRUPT MODE. For details, refer to the KCA-410C Owner’s
Manual.
If an Optional Docking Station is used for
IVA-W205R
Optional Portable
Navigation
Portable Navigation Slot
Push
Auxiliary Device
(Optional)
WARNING
It is dangerous for the driver to watch the TV/Video while
driving the vehicle. The driver may be distracted from
looking ahead and an accident could occur.
Install the IVA-W205R/IVA-W202R correctly so that the
driver cannot watch TV/Video unless the vehicle is
stopped and the emergency brake is applied.
If the IVA-W205R/IVA-W202R is not installed correctly,
the driver will be able to watch the TV/Video while driving
the vehicle and may be distracted from looking ahead
and cause an accident. The driver or other people could
be severely injured.
68-08564Z42-A_F.book Page 50 Wednesday, January 24, 2007 2:26 PM