Filter
Top Products
BASIC OPERATIONS (CONT.)
2) Press the IN BUTTON
(15). This will set the
starting point of the
SEAMLESS LOOP. The
IN BUTTON (15) LED
will flash then glow.
1) Press PLAY/PAUSE
BUTTON (13) to
activate playback
mode.
Figure 18Figure 17
©American Audio® - www.AmericanAudio.us - Radius 1000™ Instruction Manual Page 21
Figure 16Figure 15
Storing A Cue Point:
Once you have set your CUE Point by one of the two means listed on page 20, you may store your cue point
in one of the BANK BUTTONS (26). Once you store this cue point in memory you may recall it at any time and
you may even recall memory if the disc has been removed or power had been disconnected, see INTERNAL
OPERATING MODES on page 17. You may store a maximum of three cue points per a disc and maximum of
1500 cue points can be saved in unit's memory. Either a CUE POINT or a SAMPLE (See creating a sample loop
on page 23 and 24) can be stored into a BANK BUTTON (26) not both. To Store a cue point:
1) Create a Cue Point by one of the two means listed on page 20. Press the MEMORY BUTTON (27), as in
Figure 15. The red Memory Cue LED will glow indicating the store memory function has been activat-
ed. You may now press any one of the three BANK BUTTONS (26) to store your cue point into memory
(Figure 17). After pressing one of the BANK BUTTONS (26), the corresponding Bank Button LED will flash
briefly. The LED on the the BANK BUTTON (26) will remain lit indicating either a sample or cue point is
stored in memory. The red Memory LED will turn off.
2) Repeat the above steps to store up to three Cue Points. Once your three cue points have been stored you
may access them at any time. During playback the cue points will instantly start playback from that point
without any music interruption. Please note in order to access these cue point, the disc used to create the
cue points must be loaded in the drive.
10. CREATING AND PLAYING A SEAMLESS LOOP
A seamless loop is a sound loop that plays continuously without sound interruption. You can use this loop to
create dramatic effect in your mixing. This loop has no time limit and you could actually loop the entire length
of disc. You create a seamless loop between two continuous points of a disc.