Filter
Top Products
©American Audio® - www.AmericanAudio.us - Radius 1000™ Instruction Manual Page 26
BASIC OPERATIONS (CONT.)
TIME BAR INDICATOR (47) - Details the time defined in the TIME METER (49) as a visual bar icon. As with
the TIME METER (49) this bar is also dependent on the selected time function [TOTAL REMAIN, REMAIN OR
ELAPSED]. This bar will begin to flash when a track is ending regardless of which time function you are in.
Use the flashing bar as a visual reminder that a track is ending.
14. CHANGING THE TIME METER (49)/TIME BAR (47):
DURING NORMAL PLAYBACK, pressing the TIME BUTTON (29), will change the
time display information (47 & 49) in the VFD (2). The following is a break down
of the time settings and their definitions:
1) ELAPSED (48)- This describes the time in the VFD (2) as the current
TRACKS Elapsed running time.
2) REMAIN (48) - This describes the time in the VFD (2) as the current TRACKS
remaining running time.
3) TOTAL REMAIN (48) - This describes the time in the VFD (2) as the disc total
remaining running time.
Figure 32
SYSTEM MEMORY
15. RECALL MEMORY:
The Radius 1000 can store 1500 programmed cue points and effect parameters in to memory. These setting
may be recalled at any time, even when a disc has been removed and loaded at a later time. To recall the
memory on a specific disc; 1) Be sure a CD is not loaded in to the drive. 2) Press the MEMORY BUTTON (27)
down until the memory button LED begins to flash. 3) Insert the CD. "RECALL" will appear in the VFD (2) while
the memory is being installed and the memory button LED will turn off.