Filter
Top Products
CAUTION:
• The VFD is designed to be clearly visible at any angle but is best viewed within the angles shown
in Figure 2.
1. Checking the Contents
Be sure your Radius 1000™ was shipped with the following:
1) Radius 1000™ Professional CD player. 2) User Guide and Reference Manual
3) One (1) set of RCA cables. 4) One (1) 1/8” Relay Cable.
5) USB Cable. 6) Warranty card.
2. Installing the Units
Place your unit on a flat surface or mount it in a flat surface case
3. Connections
1) Be sure the power is disconnected.
2) Connect the included RCA cable from your Radius 1000™ outputs to the inputs on your
mixer.
3) Use the supplied 1/8” mini plug cable to connect your Radius 1000™ to a mini jack
connection (A or B ) on a compatible American Audio® or American DJ® “Fader Q Start”
mixer. (This will enable the Fader “Q” Start function)
CAUTION:
• Be sure to use the supplied mono 1/8" control cables. Using other types of cable may result
in unit damage
• To avoid severe damage to the unit, be sure the power is off when making connections to
the unit.
SET-UP
CAUTION:
• The player will work normally when the main unit is mounted with the front panel within 15
degrees of the vertical plane If the unit is tilted excessively, discs may not be loaded or unloaded
properly. (Figure 1)
Figure 1
15˚
Figure 2
©American Audio® - www.AmericanAudio.us - Radius 1000™ Instruction Manual Page 8
FOR BEST CD-R DISC PLAYBACK RESULTS IN THIS CD PLAYER PLEASE FOLLOW THESE
GUIDELINES:
1. High quality CD-R Audio discs (should conform to the standards of the Orange Book 2).
2. Use a high quality bit rate when recording discs. (At least 160kbps)
3. Record discs in the slowest speed possible. (i.e. 2x or 4x speed)
50˚
10˚