Filter
Top Products
39
Barcelona RCM 104A
DEUTSCH
ENGLISH
ITALIANO
PORTUGUES
NEDERLAND
ESPAGÑOL
SVENSKA
FRANÇAIS
Automatic seek tuning start
Prerequisite:
The priority for traffic announcements is ac-
tivated. If you leave the reception area of your
traffic program while listening to a tape or
disc or when having turned down the volume
completely, the car radio will automatically
tune into another traffic program station.
If no such traffic program station is found
within approximately 30 seconds, tape or
disc reproduction will be interrupted and the
system will release a warning beep. To
switch the beep off, proceed as described
above.
Adjusting the traffic message
volume
The volume of the warning beep and of the
current traffic message was pre-adjusted at
the factory. If you would like to alter the
setting, proceed as described under “DSC
programming - TA LEVEL”.
Traffic Memo (TIM)
This set is equipped with a digital speech
memory, allowing up to 4 traffic messages
lasting a maximum of 4 minutes to be auto-
matically recorded.
As soon as “TP” is displayed, the system will
record all incoming traffic announcements of
the adjusted station.
If the priority for traffic announcements is
activated (“TA” lights up in the display), the
set will also record the traffic messages of the
traffic station program within the same radio
network (see also “Reception of traffic an-
nouncements with RDS-EON”).
Depending on the length of the new traffic
bulletin, the oldest messages will be deleted.
If a message is longer than four minutes, the
system will display OVERFLOW after four
minutes of playback, and release a beep tone
to indicate that the message could only be
recorded partially.
Warning
The motor antenna could be damaged in
a car wash.
If you have installed a motor antenna, then
please take into account the corresponding
warning note at the end of this chapter.
Recalling stored traffic announcements
• Press the TIM button briefly.
The display for example shows: NDR2 (sta-
tion name or frequency), then briefly
T4 14.30 (T4 = traffic message 4, recorded
at 14:30). If four traffic messages were recor-
ded, then “T4” always represents the most
recent announcement, which will also be
played first.
Use the
/ rocker button to switch between
T1 and T4.
Hold down the
/ rocker button to move
through the message in forwards/backwards
direction quickly.
Press << to go back to the beginning of the
currently played message.
The TIM function is switched off by either
pressing TIM or >>.
TIM standby mode when the radio is
turned off
With this system it is possible to record inco-
ming traffic announcements automatically at
pre-determined times when the radio is tur-
ned off.
You may then recall such messages as des-
cribed above.
If you press the TIM button while a traffic
announcement is being played (TA lit up in
the display), the recording will be interrupted.