Filter
Top Products
Barcelona RCM 104A
32
Do not connect the loudspeaker outputs to
ground!
Use only the accessory and replacement
parts approved by Blaupunkt.
Optical indication of theft protection
When the car is stationary, you can let the
KeyCard tongue flash in order to indicate that
the set is equipped with security coding. Use
DSC to select one of two settings: LED ON or
LED OFF.
For more information, please read through
chapter “DSC programming - LED ON/OFF”.
KeyCard
The car radio can only be operated using
either KeyCard 1 or 2. Their codes are stored
in the unit.
Turn on the set and introduce the KeyCard
completely. The car radio is now ready for
operation. When inserting a wrong KeyCard,
the display will show “----”.
After approximately 10 seconds, “CARD
ERR” will appear in the display. In this case
do not make any further adjustments until
you have the corresponding KeyCard availa-
ble.
Never try to pull out the KeyCard by force.
First, slightly press the card in. This releases
the KeyCard; the display shows
“LEARNING”. Now you can pull out the card.
Should the KeyCard be lost or damaged,
then please contact one of our authorised
service partners to get a new card.
The service centres are marked (
) in the car
radio service centre list. In case of doubt,
please contact the central service centre in
your country for more information on the
KeyCard service centre closest to you.
Use either KeyCard (1 and 2) to individually
store the following functions as desired:
bass, treble, balance and fader settings, pre-
set stations, loudness, TA (traffic announce-
ment volume), SPEECH (tone control for
speech programs), BEEP volume, SCANTI-
ME, VOLFIX.
In addition to this, the settings activated be-
fore switching the radio off, such as the
waveband, station, TA priority, loudness, AF,
CPS, Dolby B/C, RM, REG ON/OFF or seek
tuning sensitivity will also remain stored.
When you insert your KeyCard, the basic
settings you have programmed will automa-
tically be activated.
Replacing a KeyCard
Any KeyCard can only be replaced by a new
one with the same number (1 or 2). Should
you wish to replace KeyCard 2, for example:
• Insert KeyCard 1 and switch the radio
on.
• Slightly press the card and it will move
into the removal position. “LEARNING”
will then appear in the display.
• Remove KeyCard 1 and insert the new
KeyCard 2 while the display is still
showing LEARNING.
Now you can operate the set with the new
KeyCard 2.
You can switch the radio on only after inser-
ting either a KeyCard 1 or 2.