Filter
Top Products
29
Barcelona RCM 104A
DEUTSCH
ENGLISH
ITALIANO
PORTUGUES
NEDERLAND
ESPAGÑOL
SVENSKA
FRANÇAIS
the corresponding slot above the Key-
Card tongue.
Read also the information given in the
“KeyCard” chapter.
9 AF button (alternative frequency) du-
ring RDS operation
When “AF” lights up in the display, the
system will automatically seek a fre-
quency offering better reception of the
same RDS program.
“AF” on/off: Press the AF button briefly.
When pressing the AF button for about
2 seconds, the display will show REG-
ON or REG-OFF (see also chapter
REG - Regional).
: PTY button (Program Type)
Activates the PTY mode. In the PTY
mode, the station buttons become pro-
gram buttons, for programs such as
NEWS, SPORT, POP MUSIC,
SCIENCE, etc.
; TIM/TA
TIM (TraffIc Memo)
To play all the stored traffic announce-
ments:
Press TIM briefly.
To activate/deactivate the priority for
traffic announcements:
Press TIM for approximately 2 seconds.
TA (Traffic Announcement)
If TA lights up in the display, the system
will only play traffic stations.
TA on/off: Press the TIM button for
approximately 2 seconds.
Note the warning under “Traffic
Memo (TIM)”.
< 1, 2, 3, 4, 5, 6 - preset buttons
You can store 6 stations on each FM
memory bank (I, II, and “T“) and
another 6 stations on MW and LW
each.
To store a station: Press button during
radio operation and hold down until the
radio comes on again.
To recall a station: Select the wave-
band. On FM, select the desired memo-
ry bank and press the corresponding
preset button.
= PS
Preset Scan
Press button briefly to scan the stations
stored on the preset buttons.
SCAN
For briefly playing all receivable stati-
ons or the titles during tape or changer
operation (option).
To start/stop Scan: Press PS for ap-
prox. 2 seconds.
The scan time can also be altered (see
chapter “DSC programming” - SCANTI-
ME).
> RM (Radio Monitor)
Press this button to listen to the radio
while fast forwarding or fast rewinding
the tape.
During tape operation:
To switch RM on/off: Press RM.
When this function is activated, the
display shows “RM”.
The radio is played during fast tape run.
? B•C – Dolby B•C NR
This set allows you to play back tapes
that have been recorded with Dolby-B
NR, Dolby-C NR or without Dolby noise
reduction.
Press B•C to adjust to the type of Dolby
NR in which the tape was recorded or
to disengage Dolby NR. When Dolby is
active, the corresponding indicator “B”
or “C” will light up.