Filter
Top Products
Barcelona RCM 104A
40
1.5 hours
The motor antenna
will be extracted
start
adjusted
TIM-TIME
end
1.5 hours
• Use the rocker button / to choose
TIM-TIME in the DSC menu.
• Press << or >> to call up the adjusted
time.
If TIM OFF is displayed, the TIM
function is deactivated.
• Use the rocker button
/ to set the
time.
• Use << to move to the hours or >> to
adjust the minutes.
Confirm your entry by
• pressing -dB or DSC.
The TIM-TIME is stored.
TIM will be active 1.5 hours before and after
the adjusted TIM-TIME.
Also, TIM will automatically stay on standby
for three hours after the radio was turned off.
When TIM is activated, the display will briefly
show “TIM ON” when the set is switched off.
Deactivating the TIM standby mode
• Press DSC with the radio being turned
on.
• Use the
/ rocker button to select the
item TIM TIME.
• Press -dB and switch to TIM OFF with
rocker button
/ (you find this item
between the time settings for 23:00 and
0:00).
When TIM OFF is flashing,
• press DSC or -dB.
If the motor antenna is retracted immediately
after selecting TIM OFF, you can be assured
that the TIM function is deactivated.
Note:
If the TIM function is not used for a longer
period of time, we recommend you to switch
it off in order to avoid that the battery goes
flat.
Warning
The motor antenna could be damaged in
a car wash.
If you have a motor antenna installed, it will
remain extracted after you have turned off
the radio with the TIM function being activa-
ted. The antenna may also be extracted in
the car wash when the set is turned off and
the TIM function activated.
When pressing TIM once again, you will hear
the message text recorded until that interrup-
tion.
Setting the time in the DSC menu:
TIM needs the exact time in order to operate
precisely. The time also has to be re-adjusted
after every interruption of the power supply.
• Press DSC and the time will be display-
ed.
• Press << to set the hours or >> to ad-
just the minutes.
The corresponding value is flashing.
To change the setting,
• press the rocker button
/ .
To confirm your entry,
• press -dB or DSC.
When pressing the -dB button, you can go on
working in the DSC menu immediately.
Adjusting the TIM standby mode/TIM
time
The TIM-TIME to be set corresponds to the
planned departure time. TIM will then be
active 1.5 hours before and after this adju-
sted time, so that the traffic messages will be
recorded during a period of three hours.
Note: During this period, a motor antenna will
remain extracted. Please take into account
the warning note of the end of this chapter.