Filter
Top Products
14 VRX6671z
6. DCP
2. Lock the DCP/Operation Panel at the upper
center until a click is heard.
3. Press the power button 1 to turn on the
power .
CAUTION
• The DCP can easily be damaged by shocks.
After removing it, be careful not to drop it
or subject it to strong shocks.
• If the Operation Panel is kept open, the DCP
may drop due to vibration of the car. This
results in damage to the DCP. So close the
Operation Panel or remove the DCP to store
into the case.
• The connector connecting the main unit and
the DCP is an extremely important part. Be
careful not to damage it by pressing on it
with fingernails, screwdrivers, etc.
Note:
• If the DCP is dirty, wipe off the dirt with a soft, dry
cloth only.
The control panel can be detached to prevent
theft. When detaching the control panel, store it
in the DCP (DETACHABLE CONTROL PANEL)
case to prevent scratches.
We recommend taking the DCP with you when
leaving the car.
Removing the DCP
1. Turn the power off.
2. Deeply push in the DCP RELEASE lever 6
to release the DCP/Operation Panel.
3. Pull the DCP toward you and remove it.
Attaching the DCP
1. Hold the DCP/Operation Panel with its rear
side facing the main unit and, as shown in
the figure below, put the lower edge of the
panel onto the corresponding edge of the main
unit.
DCP/RALEASE lever
DCP/Operation Panel
POWER button