Dual XDVD8130 Car Video System User Manual


 
3
Please read all instructions carefully before attempting to install or operate.
Due to its technical nature, it is highly recommended that your DUAL XDVD8130 is
installed by a professional installer or an authorized dealer. This product is only for use in
vehicles with 12VDC negative ground only.
Safety Notes:
The DVD video display of the in-dash unit will not operate while the vehicle is moving.
This is a safety feature to prevent driver distraction. In-dash DVD video functions will only
operate when vehicle is in Park and the parking brake is engaged. It is illegal in most
states for the driver to view video while the vehicle is in motion.
To prevent damage or injury:
1. Make sure to ground the unit securely to the vehicle chassis ground.
2. Do not remove the top or bottom covers of the unit.
3. Do not install the unit in a spot exposed to direct sunlight or excessive heat or the
possibility of water splashing.
4. Do not subject the unit to excessive shock.
5. When replacing a fuse, only use a new one with the prescribed rating. Using a fuse
with the wrong rating may cause the unit to malfunction.
6. To prevent short circuits when replacing a fuse, disconnect the wiring harness first.
7. Use only the provided hardware and wire harness.
8. You cannot view video while the vehicle is moving. Find a safe place to park and
engage the parking brake.
9. If you experience problems during installation, consult your nearest DUAL dealer.
10. If the unit malfunctions, press the reset button first. If the problem still persists,
consult your nearest DUAL dealer or call tech assistance @ 1-866-382-5476.
11. To clean the monitor, wipe only with a dry silicone cloth or soft cloth. Do not use a
stiff cloth, or volatile solvents such as paint thinner and alcohol. They can scratch the
surface of the panel and/or remove the printing.
12. When the temperature of the unit falls (as in winter), the liquid crystal inside the
screen will become darker than usual. Normal brightness will return after using the
monitor for a while.
Additional notes:
1. When extending the ignition, battery or ground cables, make sure to use automotive-
grade cables or other cables with an area of 0.75mm (AWG 18) or more to prevent
voltage drops.
2. Do not touch the liquid crystal fluid if the LCD is damaged or broken. The liquid crystal
fluid may be hazardous to your health or fatal. If the liquid crystal fluid from the LCD
contacts your body or clothing, wash it off with soap immediately.
Safety Information
XDVD8130 PREPARATION