Filter
Top Products
30
Problem Cause Action
Unit will not turn on
(no power)
Yellow wire not connected or incorrect voltage
Red wire not connected or incorrect voltage
Check connections for proper voltage
(11~16VDC)
Black wire not connected Check connection to ground
Fuse blown Replace fuse
Unit has power
(but no sound)
Speaker wires not connected Check connections at speakers
One or more speaker wires touching each other
or touching chassis ground
Insulate all bare speaker wires from each
other and chassis ground
Unit blows fuse
Yellow or red wire touching chassis ground Check for pinched wire
Speaker wires touching chassis ground Check for pinched wire
Incorrect fuse rating Use fuse with correct rating
Unit has audio
(but no video)
Parking brake safety circuit not connected
Parking brake not applied
Check connections at parking brake
Apply parking brake
No subwoofer output or
low subwoofer output
Subwoofer mode is not active
Subwoofer output level is turned down
Activate subwoofer mode - see page
11
Increase subwoofer output level
No V3 video display
(when in reverse)
Reverse circuit not connected
Vehicle is not in reverse
Check connections at reverse lamp
Select reverse gear
IR remote does not work
Dead batteries
Remote set to control wrong model
Replace batteries
Select XDVD8130 - see page 9
Excessive skipping
Unit is not mounted correctly or backstrap is
not secure
Check mounting sleeve and backstrap
support
Physical defect in media Check media for scratches
ERROR-01 appears
on display
Disc mechanism error Press eject or RESET
ERROR-02 appears
on display
Focus error or disc is in upside down Press eject or RESET
ERROR-03 appears
on display
Region code error Use only DVDs labeled “Region 1” or
“All” only
Unit will not accept
a disc
Disc mechanism position out of alignment Press EJECT for 3 seconds to reset
disc mechanism position
Disc mechanism transit screws still in place Remove 2 transit screws located on top
of the unit
Copyright Notes
This product incorporates copyright protection technology that is protected by method claims of
certain U.S. patents and other intellectual property rights owned by Macrovision Corporation and
other rights owners. Use of this copyright protection technology must be authorized by Macrovision
Corporation, and is intended for home and other limited viewing uses only unless otherwise
authorized by Macrovision Corporation. Reverse engineering or disassembly is prohibited.
Manufactured under license from Dolby Laboratories. “Dolby” and the double-D symbol are
trademarks of Dolby Laboratories.
Windows Media and the Windows logo are trademarks, or registered trademarks of Microsoft
Corporation in the United States and or other countries.
XDVD8130 OPERATION
Troubleshooting