Filter
Top Products
ķ
11
Power Supply
Mains Operation
Only use a mains unit with the correct output voltage of 9V = and cor-
rect polarity
} .
Connect the mains unit to the DC 9V
socket. This disconnects the
inserted batteries.
Battery Operation
with six 1.5 Volt batteries, type IEC LR 6 / UM-3/AA.
We recommend the use of alkaline-manganese batteries with low
mercury percentage or no mercury at all.
Disconnect the plug of the mains unit from the DC 9V
socket.
Open the cover of the battery compartment (at back of unit).
Insert batteries with correct polarity (see scheme above battery com-
partment).
Observe correct order of batteries when fitting them.
No responsibility can be accepted for damage due to incorrect
mains operation.
Remove the batteries if you intend to operate the unit permanent-
ly on the mains!
Battery Check
When the batteries get weak, the indication will flash in
the display.
When the radio is switched on, it will switch off after a short time.
Attention
Remove exhausted batteries immediately from the unit!
If the unit is not to be used for long periods, also remove new
batte-
ries!
No responsibility can be accepted for damage caused by leaking bat-
teries.
Protect the Environment!
Do not throw exhausted batteries in the household waste!
When buying new batteries, hand over the old ones to your radio
dealer or a special collecting point.
8.I.8.0.0
8 6:3 0
0 0
ON-TIME
TIME I
BATT. CHECK
:
BATT. CHECK