Filter
Top Products
Your Unit at a Glance
ķ
4
Display
Optimum read-off quality will be obtained when the set is brought into
a tilted position. For this, use the swing-out support at the back of the
unit.
ON-TIME
Wake-up time/switch-on time
If ON-TIME is indicated, the wake-up time is shown
below (in the left numeric block).
88:88 Left numeric block
a. With radio switched on:
1) Clock time indication (TIME I or TIME II).
2) Wake-up time indication (can be called up by
pressing the
¢ AUTO button).
3) Sleep time indication.
b. With radio switched off: Wake-up time indication.
Battery check
When this indication appears, the batteries should be
replaced.
Tuning/field strength indication
The reception quality corresponds to the length of the
tuning bar.
TUNING
0...1... 2 ...3...4 ...5
IIIIIIIIIIIIIIIIIIII
BATT. CHECK
8.8.8.8.8
8 8:8 8
8 8
ON-TIME
TIME II
SLEEP LOCK
kHz
MHz
FREE
m kHz
MEMORY
STEP
BATT. CHECK
TUNING
0 . . . 1 . . . 2 . . . 3 . . . 4 . . . 5
FM
LW
MW
SW
:
ɷ ʍ Wake-up mode symbols
You can select the wake-up mode (radio
ɷ or sound
signal
ʍ) by pressing the ¢ AUTO button.
TIME II
Time I/II
You can select between two times (2 different time
zones).
Indication of the respective time:
– In the left numeric block with the radio switched on.
– In the large numeric block with the radio switched
off.
Sleept time
A sleep time (operating time) is entered (10, 20, 30,
40, 50 or 60 minutes).
When entering the time, it will briefly be indicated in
the left numeric block.
When this indication is visible, all buttons are locked,
except
– the
¢ ON/OFF button (this can further be used to
switch off
the radio);
– the
¶ SNOOZE button (the functions of this but-
ton are retained).
LOCK
SLEEP