Filter
Top Products
ķ
17
Station Tuning
Automatic tuning (AUTO TUNING)
This frequency search
is started by pressing the ¢ AUTO TUNING
button.
Short presssure
: Search is started in direction of higher frequencies.
Long pressure
: Search is started in direction of lower frequencies.
The search function operates with the tuning steps
9 kHz on LW,
5 kHz on SW,
9 or 10 kHz on MW.
If a lower step value has been adjusted, the unit will automatically se-
lect the tuning steps indicated above. For 9 kHz/10 kHz switching on
MW, see chapter "Adjusting the tuning steps", page 16.
The automatic search will stop as soon as it has found a station with
sufficient field strength for good reception. It can then be restarted
with the ¢ AUTO TUNING button (brief or long pressure).
Station Tuning with the Numeric Buttons
(Direct frequency entry)
For this, the frequency of the station you wish to tune to must be
known. You can find these frequencies in station tables or radio gui-
des. You can enter the frequency in MHz
or kHz, or as meter band on
SW
.
Confirm the entries with the
¢ FREQU./METER button.
On FM
: MHz indication.
On AM
: kHz indication.
Examples:
Desired frequency Entry order
99.00 MHz 99. ɮ ¢ FREQU./METER button
99.00 MHz 99.0
ɮ ¢ FREQU./METER button
99.00 MHz 99.00
ɮ ¢ FREQU./METER button
99.10 MHz 99.1
ɮ ¢ FREQU./METER button
99.10 MHz 99.10
ɮ ¢ FREQU./METER button
99.10 MHz 99.100
ɮ ¢ FREQU./METER button
7000 kHz 7000
ɮ ¢ FREQU./METER button
It is absolutely necessary to enter the decimal point, even if no fur-
ther figures follow. The decimal point is the indication that the entry
is made in MHz. Without decimal point, the entry is interpreted as kHz
entry.