Filter
Top Products
Station Tuning
ķ
16
Adjusting the tuning steps
The tuning steps are adjusted with the
¢ STEP button.
With the unit switched on, you can switch between
:
1 kHz or 9 kHz on LW
1 kHz or 5 kHz on SW
1 kHz or 9 resp. 10 kHz on MW.
The respective waveband must be selected.
Repeatedly press the
¢ STEP button until the desired tuning step
value (e.g., in the figure, STEP 9KHZ) is indicated in the display.
With the unit switched off, you can switch between the tuning steps
9 kHz and 10 kHz (for USA radio stations) in the MW band.
If the unit is not yet switched off, do this.
Press the AM button, then repeatedly press the
¢ STEP button until
the desired step value is indicated in the display.
After approx. 5 seconds, the display will indicate again the clock time.
You can switch between 5 kHz and 10 kHz tuning steps
– as soon as the AM button has been pressed after switching off the
unit,
– until you switch the unit on again.
8.8.I.5.3
I 8:0 0
8 9
TIME I
kHz
MHz
FREE
m kHz
MEMORY
STEP
BATT. CHECK
TUNING
0 . . . 1 . . . 2 . . . 3 . . . 4 . . . 5
FM
LW
MW
SW
This is a precaution to avoid accidental tuning step switching.
When activating the automatic tuning mode, the unit automatically
switches to the higher tuning step. However, the 9 kHz or 10 kHz
choice in the MW band is retained.
Manual tuning
– Tune to the desired station by briefly
pressing on the 0 TUNING Ń
or TUNING Ľ button.
Each pressure on the button performs a tuning step of the value
adjusted for the respective waveband (FM: 50 kHz, AM: see chap-
ter "Adjusting the tuning steps").
– When keeping pressed
the 0 TUNING Ń or TUNING Ľ button, the
respective waveband will be scanned at high speed with the tuning
steps selected for it. Releasing the pressed button will stop scan-
ning.
8.8.8.I.0
8 6:3 0
0 0
ON-TIME
TIME I
kHz
MHz
FM
LW
MW
SW