Jensen MP8610BT Car Stereo System User Manual


 
MP8610BT
12
2
MP8610BT
PH
O
N
E
AS/PS
MP3/WMA RECEIVER
/
PTM
MOSFET
72
WATTS
1
RESET
32
Operation (continued)
Using the Detachable Control Panel (DCP)
When attaching or detaching the control panel, be careful not to damage the rear connector
that connects the DCP to the main unit.
Detaching the Control Panel
To detach the front panel, press the REL button (
29) to release the front panel. Grasp the left
side of the front panel pull gently to remove it from the unit. Store the front panel in a safe place
to protect it from dirt and damage. Do not drop the DCP, as this type of shock could cause
damage.
NOTE: Once the release button is pressed and the DCP is unlocked, the vehicle’s
vibrations could cause it to fall off. After pressing the Release button, remove the
control panel immediately or press it back into position.
Re-attaching the Control Panel
To re-attach the panel, first make sure there is no dust or dirt on the electrical terminals on the
back of the panel, as this could cause intermittent operation or other malfunctions. Slip the front
panel right edge into position first, then rotate the left side of the front panel into position and
press firmly into place.
NOTE: To prevent damage to the DCP, DO NOT insert it from the left side.
Cleaning the Control Panel
If the control panel becomes dirty, wipe it with a soft, dry cloth only. Use a cotton swab soaked
with isopropyl alcohol to clean the socket on the back.
Resetting the Unit
To reset the unit, release the front panel, then use a pencil (or any non-metallic object) to press
and hold the RESET button (32) for five seconds.
Detaching the Front Panel
Liberar el Panel Delantero
Détachement du panneau d'avant
Reset Button
Botón Reset
Bouton Reset