Filter
Top Products
53
ENGLISH
Assigning names to the sources
You can assign names to CDs (both in this unit
and in the CD changer) and the external
component (LINE IN).
After assigning a name, it will appears on the
display when you select the source.
Sources
Maximum number of
characters
CDs/CD-CH* Up to 32 characters (up
to 40 discs)
External component Up to 8 characters
(LINE IN)
* You cannot assign a name to a CD Text or an MP3/
WMA disc.
1
Select a source you want to assign a
name to.
When you select a source, the power
automatically comes on.
2
While pressing D DISP, press and
hold SEL (select) for more than
2 seconds.
The next-step-operation buttons start
flashing.
3
Select the character set you want
while the first character position is
flashing.
Each time you press the
button, the character set
changes as follows:
4
Select a character.
• About the available
characters, see page
73.
5
Move the cursor to the next
(or previous) character position.
6
Repeat steps
3
to
5
until you finish
entering the name.
7
Finish the procedure while the last
selected character is flashing.
To erase the entered characters
To erase all the characters at a time, press and
hold D DISP for more than 1 second as
described in the procedure above.
Notes:
• When you try to assign a name to the 41st disc,
“Name Full” appears and you cannot enter the text
entry mode. In this case, delete unwanted names
before assignment.
• When the CD changer is connected, you can assign
names to CDs in the CD changer. These names can
also be shown on the display if you insert the CDs
in this unit.
Ex.: When you select CD as the source
EN45-55_KD-LH401[E_EX]f.p65 6/2/04, 9:18 AM53