Filter
Top Products
11
ENGLISH
RADIO OPERATIONS
Selected band appears.
Lights up when receiving an FM stereo
broadcast with sufficient signal strength.
FM1 FM2 FM3 AM
SRC
The operations of this section are mainly
explained using the buttons on the control panel.
When the remote controller can be used for the
same operations, it is then explained.
Listening to the radio
You can use either automatic searching or manual
searching to tune in to a particular station.
Searching for a station automatically:
Auto search
This operation is also possible from the remote
controller.
1
Select the band (FM1 – 3, AM).
1 Press SRC (source)
repeatedly to select the tuner.
2 Press and hold SRC.
Each time you press and hold
the button, the band changes.
Note:
This receiver has three FM bands (FM1, FM2,
FM3). You can use any one of them to listen to an
FM broadcast.
2
Start searching for a station.
When a station comes in, searching stops.
To stop searching before a station is received,
press the same button you have pressed for
searching.
When using the remote controller
1
Press FM or AM.
• When selecting the FM bands,
press FM repeatedly until the
band you want is selected.
2 Press ¢ or 4 to start
searching.
AM
FM
DAB
To search for stations of
higher frequencies
To search for stations of lower
frequencies
3456 EQ21
D
SRC
DISP
ATT
SEL
MODE
M
EN11-15DV5000[U]f.p65 03.5.15, 14:2811