Filter
Top Products
14
ENGLISH
1
FM1 FM2 FM3 AM
Tuning in to a preset station
You can easily tune in to a preset station.
Remember that you must store stations first. If
you have not stored them yet, see “Storing
stations in memory” on pages 13 and 14.
Selecting a preset station directly
1
Select the band (FM1 – 3, AM).
1 Press SRC (source)
repeatedly to select the tuner.
2 Press and hold SRC.
Each time you press and hold
the button, the band changes.
2
Select the number (1 – 6) for the
preset station you want.
Note:
You can also use the 5 (up) or ∞ (down) button on
the unit to select the next or previous preset stations.
Each time you press the 5 (up) or ∞ (down) button,
the next or previous preset station is tuned in.
When using the remote controller
1
Press FM or AM.
• When selecting the FM bands,
press FM repeatedly until the
band you want is selected.
2 Press the number buttons (1 to 6) while
holding SHIFT (S).
Note:
You can also use the PRESET (FOLDER) 5 / ∞
buttons for selecting a preset station.
345621
SRC
AM
FM
DAB
2
Tune in to a station (in this example,
of 92.5 MHz).
3
Press and hold the number button
(in this example, 1) for more than
2 seconds.
4
Repeat the above procedure to store
other stations into other preset
numbers.
Notes:
• A previously preset station is erased when a new
station is stored in the same preset number.
• Preset stations are erased when the power supply to
the memory circuit is interrupted (for example,
during battery replacement). If this occurs, preset
the stations again.
S
SHIFT
TOP
MENU
564
23
1
DISC
ENTER
MENU
+
To tune in to stations of
higher frequencies
To tune in to stations of
lower frequencies
The display pattern automatically changes like the
above pattern (see page 15). The preset number
flashes for about 5 seconds, then the previous
display pattern resumes.
EN11-15DV5000[U]f.p65 03.5.15, 14:2814