Filter
Top Products
57
n Transmitting Stored DTMF Codes
1 Press and hold the microphone [PTT].
2 While transmitting, press the Tuning control.
• The last called DTMF Memory channel name and number appear on the display.
If no name has been saved for the channel, the DTMF code appears.
3 While still transmitting, rotate the Tuning control to select your desired
DTMF Memory channel, then press the Tuning control to set the channel.
• Additionally, you can press a DTMF key corresponding to your desired channel
([0] ~ [9]) to select the channel and begin transmission.
• The stored DTMF code scrolls across the display and is transmitted.
• The code will be transmitted even if you release
[PTT] before the entire code has
scrolled across the display.
• If no DTMF code is stored in the selected channel, the frequency display is
restored.
n Selecting a Transmit Speed
Some repeaters may not respond correctly if a DTMF code is transmitted at
fast speed. If this happens, change the DTMF code transmission speed from
FAST (default) to SLOW.
1 Enter Menu mode and access Menu 302 (DT.SPD) {page 20}.
2 Set the speed to FAST or SLOW.