Filter
Top Products
Connecting the 910 Digital Audio Preamplifier
9
9
6 Connecting the 910 Digital Audio Preamplifier
To connect the 910 as illustrated in the example in Figure 2
1
1. Connect the inputs:
:
• Connect an unbalanced stereo source (for example, a tape
recorder) to the left and right INPUT 1 RCA connectors
• Connect an balanced stereo source (for example, a tape
recorder) to the left (L+, L-), right (R+, R-) and ground (G)
terminals on the INPUT 2 terminal block connectors
• Connect a digital audio source (for example, a digital audio
player) to the INPUT 3 S/PDIF RCA connector
• Connect a microphone to the INPUT 4 MIC XLR connector
(see
Section 6.4
2. Connect the outputs:
). Set the MIC MODE button to Dynamic or
Condenser (pressed in)
• Connect the left and right OUTPUT 1 RCA connectors to an
unbalanced stereo audio acceptor (for example, a power
amplifier)
• Connect left (L+, L-), right (R+, R-) and ground (G) terminals
on the OUTPUT 2 terminal block connectors to a balanced
stereo audio acceptor (for example, a power amplifier)
• Connect the OUTPUT 3 S/PDIF connector to a digital audio
acceptor (for example, a digital power amplifier)
3. To remotely operate the 910, make any of the following connections:
• RS-232 9-pin D-sub port to a PC (see
Section 6.1
• Ethernet RJ-45 connector to a network (see
)
Section 6.2
• USB connector to a PC (see
)
Section 6.3
4. Connect the power cord
)
2
(not shown in Figure 2).
1 Switch off the power to each device before connecting it to the 910. After connecting the 910, switch on its power and then
switch on the power to each device
2 We recommend that you use only the power cord supplied with this device