Filter
Top Products
NDA-30135 Revision 1 Page 9
Attendant Monitor Operations Manual INSTALLATION & CONFIGURATION
Primary
Configuration
Parameters
From the APM Configuration Entry screen, configure the AttendantMonitor
component as follows. All parameters marked with asterisks (*) should be entered
exactly as shown. The rest of the entries in the table below are just examples.
OAI Facilities Following the instructions in the APM Operations Manual, name the following
NEAX2400 facilities for the AttendantMonitor component using the Facilities
command on the APM Configuration Entry screen:
- SCF Switch Control
- SMFR Status Request (R)
- SMFN Status Notification (N)
Continue to the next page for OAI-Conf settings...
Parameter Entry Value Description
Application Name AttendantMonitor The name to be displayed in the APM menus.
This name is displayed as it is entered
here — i.e., capital letters, lowercase, etc.
Executable Filename* /oai/app/attMonitor/
bin/attMonitor
The path name of the executable file.
Group* The group that the component belongs to.
Make no entry.
Response Mode* I(gnore) The action that the APM is to take with the
component should a member of the group
terminate.
Initialization Batch N(o) Whether (Yes or No) the component is to be
initialized automatically when the OAI system
is initialized.
Termination Mode* M(essage) How the APM is to notify the component to
terminate.
Standard Output /dev/null Where any output is sent.
Number of Restarts 0 How many times the APM may restart the
component after it terminates in error.