Filter
Top Products
Page 10 NDA-30135 Revision 1
INSTALLATION & CONFIGURATION Attendant Monitor Operations Manual
OAI-Conf Settings Use the OAI-Conf command on the APM Configuration Entry screen to make the
necessary parameter entries. For parameters shown with an asterisk (*) in the table
below, make entries exactly as shown. The other parameters are shown with
sample entries that may be changed to meet site requirements. Use the instructions
provided for this option in the APM Operations Manual:
User-Defined
Parameters
No user defined parameters are used in Attendant Monitor. Therefore, all user
defined parameters are blank.
Continue to the next page for Database Support...
Parameter Entry Value Description
Database Name #1* /oai/db/cur/tenants The path name of the tenant number
database.
Database Name #2* /oai/db/cur/Attmon The path name of the Attendant Monitor
database.
Timeout Value #1 0 Unused
Timeout Value #2 0 Unused
Tenant Number 1 Default Tenant Number
Source Link Name OAI1TCP Port on the source side of the
communication link. Entry should match a
link name in the APM system
configuration file.
Destination Link Name PBX1TCP Port on the destination side of the
communication link. Entry should match a
link name in the APM system
configuration file.
Association Recovery 30 Number of seconds Attendant Monitor
waits before trying to reestablish an
association with the NEAX that has been
released.