Filter
Top Products
NDA-30135 Revision 1 Page 11
Attendant Monitor Operations Manual INSTALLATION & CONFIGURATION
Database Support
Attendant Monitor requires two APM databases: the Attendant Monitor database
and the Tenant Number Database. These databases are created with default values
during initial software installation, but specific records must be added before
Attendant Monitor is enabled.
Attendant Monitor
Database
The Attendant Monitor database (attmon) consists of a Master Database file
component and an Application Database file component.
Master Database File - filename ’attmon’.
The attmon master database structure and example entries are shown in the table
below.
Field Definitions
- The Monitor Number field specifies the monitor number the attendant will
dial to log on and log off the system.
- The Attendant Name field specifies the attendant name that will be used in
attendant reports.
- The TTY field specifies the unique TTY device used by the attendant. Since
stand alone attendants do not use an actual TTY device, the monitored
number value may be entered again in this field to ensure that the TTY value
is unique.
- The Supervisor Flag fields specifies if the attendant is a supervisor. It may
be set to ‘Y’ or ‘y’ to indicate the attendant is a supervisor, or to ‘N’ or ‘n’
to indicate the attendant is not a supervisor.
Application Database File - filename ’Attmon’.
The Attmon application database structure is shown in the table below:
Field Name
Type Size Min.
Value
Max.
Value
Example
Entry
Monitored Number A 6 5000
Attendant Name A 8 Smith
TTY A 25 5000
Supervisor Flag A 1 n n
Field Description Data Type
Monitored Number
ASCII
Attendant Name
ASCII
TTY
ASCII
Supervisor Flag
ASCII