Onkyo TX-SR702E Car Stereo System User Manual


 
73
Advanced Setup
—Continued
Note:
This procedure can also be performed on the AV
receiver by using its [SETUP] button, arrow buttons,
and [ENTER] button.
4
Use the Up and Down [ ]/[ ]
buttons to select the signal for-
mat that you want to set, and
then use the Left and Right [ ]/
[] buttons to select a listening
mode.
Only listening modes that can be used
with each input signal format can be
selected.
For “Surround” or “THX,” the listening
mode specified on pages 68, 69 will be
used.
The Last Valid option means that the
listening mode selected last will be
used.
a. Ana/PCM:
With this setting, you
can specify the listening mode to be
used when an analog (CD, TV, LD,
VHS, MD, turntable, radio, cassette,
cable, satellite, etc) or PCM digital
(CD, DVD, etc) audio signal is played.
b. Dolby D:
With this setting, you can
specify the listening mode to be used
when a Dolby Digital format digital
audio signal is played (DVD, etc).
c. DTS:
With this setting, you can spec-
ify the listening mode to be used when
a DTS format digital audio signal is
played (DVD, LD, CD, etc).
d. D.F. 2ch:
With this setting, you can
specify the listening mode to be used
when a 2-channel (2/0) digital audio
signal (Dolby Digital, DTS) is played
(DVD, etc).
e. D.F. Mono:
With this setting, you
can specify the listening mode to be
used when a mono digital audio signal
is played (DVD, etc).
f. Multiplex:
With this setting, you can
specify the listening mode to be used
when a multiplex audio signal is
played.
g. Multich:
This setting is available
only when “5-1. DVD/MULTCH” is
selected. With this setting, you can
specify the listening mode to be used
when the DVD analog multichannel
input is used.
5
When you’ve finished, press the
[SETUP] button.
The setup menu closes.
ENTER