Onkyo TX-SR702E Car Stereo System User Manual


 
77
Zone 2
—Continued
To use Zone 2, you must make this setting. It enables the
speakers connected to the ZONE 2 SPEAKERS termi-
nals so that they produce sound when Zone 2 is used.
Note:
This procedure can also be performed on the AV
receiver by using its [SETUP] button, arrow buttons,
and [ENTER] button.
Setting the Powered Zone 2
1
Press the [RECEIVER] button fol-
lowed by the [SETUP] button.
The main menu appears onscreen.
2
Use the Up and Down [ ]/[ ]
buttons to select “1. Initial
Setup,” and then press [ENTER].
The Initial Setup menu appears.
3
Use the Up and Down [ ]/[ ]
buttons to select “3. Hardware
Setup,” and then press [ENTER].
The Hardware Setup menu appears.
2–4
2, 3
1, 5
1
RECEIVER
ENTER
ENTER
ENTER
ENTER
4
Use the Up and Down [ ]/[ ]
buttons to select “a. Powered
Zone 2,” and use the Left and
Right [ ]/[ ] buttons to select:
Not Activated:
Zone 2 SPEAKERS
terminals deactivated.
Activated:
Zone 2 SPEAKERS termi-
nals activated.
When Zone 2 is activated and turned on
(see page 78), the speakers connected
to the ZONE 2 SPEAKERS terminals
output sound, but the speakers con-
nected to the SURROUND BACK
SPEAKERS terminals do not. (When
Zone 2 is activated but not used, the
surround back speakers work as nor-
mal.)
5
Press the [SETUP] button.
The setup menu closes.
ENTER
Menu
------------------------
1.Initial Setup
2.Speaker Setup
Advanced Setup
3.Surround Setup
4.Audio Adjust
5.Listening Mode Preset
6.Preference
Basic Setup
1.Initial Setup
------------------------
2.Component Video
3.Hardware Setup
1.Digital Input
1-3.Hardware Setup
------------------------
:Not Activated
b.Sp Impedance Minimum
:6ohms
a.Powered Zone2