Filter
Top Products
11
Completing the Connections
Make sure you have securely made all
other connections, then plug the har-
ness’ connector into the stereo’s 14-pin
wiring socket. Reconnect the cable to
the vehicle battery’s negative terminal.
TESTING THE
CONNECTIONS
Turn on your vehicle’s ignition and in-
stall your stereo’s control panel (see
“Installing the Control Panel” on
Page 14). The display should light
when you press
ON/OFF
to turn on the
stereo.
If the stereo does not work,
immedi-
atel
y
disconnect the cable from
y
our vehicle batter
y
’s ne
g
ative (–)
terminal.
Then recheck your connec-
tions.
Caution:
If you played a CD while
testing the connections, be sure to re-
move the CD from the stereo before
continuing.
After you verify that the display lights,
follow the instructions in “Mounting the
Stereo.”
MOUNTING THE STEREO
Be sure you verify that the stereo is
connected properly. See “Making the
Connections” on Page 7. Then follow
these steps to mount the stereo.
1. Disconnect the cable from the
vehicle battery’s negative (–) ter-
minal.
2. Disconnect the wire harness and
the antenna.
3. Press
RLS
on the lower right-hand
corner of the control panel to
remove the control panel.
(illus)
(new illus)
(new illus)
12-2152.fm Page 11 Wednesday, July 14, 1999 2:48 PM