Filter
Top Products
8
Note: The wiring harness has the fol-
lowing labels.
Using an Adapter Harness
If you are replacing an existing stereo,
or if your vehicle has been factory-
wired for autosound components, you
might be able to use an adapter har-
ness to connect the power and speak-
ers. RadioShack stores sell adapter
harnesses for most vehicles.
Follow the directions that come with
the adapter harness to temporarily
connect the power and speakers.
Connecting Ground, Power,
and Optional Components
Follow these steps to connect the har-
ness with the 14-pin connector to
ground, primary and memory backup
power, and optional components.
1. Disconnect the cable from your
vehicle battery’s negative (
–
) ter-
minal.
2. Connect the black ground wire to
a chassis ground, such as a metal
screw attached to a metal part of
the vehicle’s frame. Be sure that
the screw is not insulated from the
chassis by a plastic part.
3. Connect the red power wire (with
in-line fuse holder) to a point in
your vehicle’s fuse block that has
power only when you turn the
vehicle’s key to either the acces-
sory (ACC) or START position.
(illus - (Black) Ground
(Yellow) +12V to Battery
(White/Black) Front Left
(Red) +12V to Ignition
(Blue/White) Amp Remote
Turn On 500 mA Max
(White) Front Left Speaker +
Speaker -
(Gray) Front Right Speaker +
(Gray/Black) Front Right Speaker -
(Green) Rear Left Speaker +
(Green/Black) Rear Left
Speaker -
(Violet) Rear Right Speaker +
(Violet/Black) Rear Right
Speaker -
(illus - show (Black) Ground
(Red) Power
(Yellow) Power/Memory
(Blue/White) Optional
Equipment
12-2152.fm Page 8 Wednesday, July 14, 1999 2:48 PM