Filter
Top Products
12
4. Insert both of the supplied keys
into the slots at the left and right
sides of the stereo. Press the keys
downward, and slide the sleeve
off of the stereo.
Note: The keys are labeled to
show their top edges.
5. Remove the keys from the slots.
6. Insert the sleeve into the dash.
Then secure the sleeve to the
dash by bending out the tabs with
a screwdriver. Bend out all the
side tabs.
7. If your vehicle has an existing
mounting hole under the dash,
use pliers or a
5
/
16
-inch box-end
wrench to attach the short end of
the supplied mounting bolt to the
back of the stereo.
8. Reconnect the wire harness and
the antenna.
9. Slide the stereo into the sleeve
until it locks into place.
10. If you are securing the stereo in
an existing mounting hole under
the dash, push the supplied rub-
ber mounting grommet onto the
mounting bolt, then push the
mounting bolt (covered by the
mounting grommet) through the
existing mounting hole and make
sure it is secure.
(illus)
(illus)
(illus)
(illus - show mounting grommet)
12-2152.fm Page 12 Wednesday, July 14, 1999 2:48 PM