Filter
Top Products
5
6
CQ-VD6503N
English
Installation Guide (continued)
❏ Mounting Procedures (A) (When using Mounting Collar w)
Mounting and removing the Display Unit
Note:
¡The car model, installation conditions and combination
of the units used may impose some restrictions on
opening and closing the monitor as well as on the
angle and position to which the monitor can be adjust-
ed.
IMPORTANT
When this unit is installed in dashboard, ensure that there
is sufficient air flow around the unit to prevent damage
from overheating. Do not block any ventilation holes on
the unit.
q
w
e
r
t
Insert the Mounting Collar w into the dash-
board, and bend the mounting tabs out with
a screwdriver.
Establish the rear connection of the unit.
After fixing Power Connector
i, fix the rear
of the unit to the car body by either method
(a) or (b).
Insert the unit into Mounting Collar w.
Secure the clamp plate of Mounting Collar
w
to the hook.
Insert Trim Plate q.
After installation reconnect the negative (–)
battery terminal.
Snapping point
q
w
e
t
(a) Using the Rear Support Strap t.
(b) Using the Rubber Cushion (option)
Fire wall of car
3 mmø
Tapping Screw (option)
(5 mmø x 16 mm)
t
Rear Support
Strap
r
Mounting Bolt
(5 mmø)
To the unit
To the unit
r
Mounting Bolt
(5 mmø)
Rear Support
Bracket
(Provided on
the Car)
Rubber Bushing
(option)
Hex. Nut (option)
(5 mmø)
Method for Fixing the Rear of the Unit
r