Filter
Top Products
CR-SRF100/CR-SRT100
8
5. Getting Initial Subscription
For Channels From Sirius
Only continue with this section after the system is installed in the vehicle and the battery is connected.
There are 3 basic steps:
1. Turn the power on by pressing the [SEL] knob/button.
(the unit’s Sirius ID number should be displayed)
(if the ID number is not displayed, skip this section … already subscribed!)
Note: If this is the first time the radio has been powered on, please leave the unit powered up for
approximately 5 minutes without operating the controls. There is transmission-specific information which
must be loaded into the receiver from the satellite signal.
2. Record the receiver’s product serial number (printed on a label on the receiver) and Sirius ID number
from the display. (See section 6.1 for information on displaying the Sirius ID.)
If your system has been powered up and a subscription for satellite
services has already been done, then SKIP this section...you are ready to
finish setting up the system or operate it.
17233_SGould 08/15/02 14:46 Page 8